32 33
Mira 200 Mira 200
THE ANSWERING MACHINE DOES NOT RECORD ANY MESSAGES AND
BREAKS THE CONNECTION AFTER THE OUTGOING MESSAGE
- Has the answering machine been set to nA-mode (answering without possibility
to record)?
Set the answering machine to An-mode (answering with possibility to record).
- Does “Fu” appear on the display of the base station?
The memory is full, erase the memory.
THE ANSWERING MACHINE CANNOT BE ACTIVATED
Record OGM 1 and 2.
THE ANSWERING MACHINE BREAKS THE CONNECTION DURING THE
RECORDING OF A MESSAGE
The maximum recording time is reached, prolong the recording time or do not
set any time limit.
The memory is full, (“Fu” appears on the display), erase the memory.
REMOTE CONTROL DOES NOT FUNCTION
Has the remote control code been entered with a telephone set to tone dialling
(DTMF)?
Has the code been entered after the beep?
Did you wait for the confirmation beep after entering each digit?
Did you hear 2 short beeps after entering the complete code?
Did you enter the correct code?
R e m a r k :
When you have dictated a message just before entering the remote control code, this
message will not be saved. If you want to leave a message, press 73 (recording a
memo message) during the remote control function and 9 to stop the recording.
During the remote control function “rE” (remote) appears on the display of the base
station to inform the possible user of the Mira 200 that the remote control function is
a c t i v a t e d .
11. TROUBLESHOOTING
THE TELEPHONE DOES NOT FUNCTION
Check the power supply of the adaptor.
Did you use the adaptor delivered with this telephone?
Has the telephone line been connected correctly?
Did you use the line cord delivered with this telephone?
Is the battery of the handset sufficiently charged?
Is the handset too far away from the base station?
NO DIAL TONE
Has the telephone cord been connected correctly? If not, connect the Mira 200
with the line cord delivered with this telephone.
OUTGOING CALLS ARE NOT POSSIBLE / WRONG DIALLING SYSTEM
Change the dialling system (pulse/tone dialling).
BAD CONNECTION
The handset is too far away from the base station, move closer.
YOU HEAR AN INTERMITTENT BEEP
during the conversation
You are too far away from the base station, if you do not move closer to the base
station within 10 seconds, the line will be broken.
when you try to establish a communication and it is impossible to
obtain the connection:
- in the beginning of a call: wait for the connection to be established.
- during a call: try again.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals