22 23
Mira 200 Mira 200
9.6. RECORDING TIME PER MESSAGE
The maximum recording time has been preset to 2 minutes (d2). In order to change
this setting, proceed as follows:
1. Bring the device in programming mode so that the previously programmed
recording time appears on the display.
2. In order to change the recording time, press the playback/fast forward
button. On the display the possible choices appear (d0-d2,d-):
d0= 30 seconds, d1= 1 minute, d2= 2 minutes, d-= no limit.
3. Press the STOP button to end the programming or the /PROG button to pass
to the following setting.
9.7. REMOTE CONTROL CODE
The code number for the remote control consists out of 3 numbers and is preset to
“123”. In order to change this code, proceed as follows:
1. Bring the device in programming mode so that “Cd” appears on the display.
2. In order to change the first number, press the rewind button. The previous-
ly entered number appears on the display. The indication “-” shows that it concerns
the first number.
3. Press the playback/fast forward button to change the number (0-9).
4. In order to change the second number, press the rewind button. The previ-
ously entered number appears on the display. The indication “=“ shows that it con-
cerns the second number.
5. Press the playback/fast forward button to change the number (0-9).
6. In order to change the third number, press the rewind button. The previ-
ously entered number appears on the display. The indication “ ” shows that it
concerns the third number.
9.4. PROGRAMMING MODE
The following settings can be changed in the programming mode.
* Number of rings before automatic answering
* Recording time per message
* Remote control code
* Speech quality
In order to bring the device in programming mode, press and hold the / P R O G
button until you hear a beep. The PROG-LED on the base station will light and on the
display the previously entered number of rings appear. Each time you want to go to a
following setting, press and release the /PROG button, the previously entered coor-
dinates appear on the display.
To stop the programming, press the STOP button. The PROG-LED turns off.
9.5. SETTING THE NUMBER OF RINGS
You can determine yourself after how many rings your Mira 200 will answer the
incoming calls. Standard this has been set to 2 rings (r2). In order to change this set-
ting, proceed as follows:
1. Bring the Mira 200 in programming mode so that the previously entered number of
rings appear on the display.
2. To change the number of rings, press the playback/fast forward button. On
the display the possible choices appear (r1-r5, ts):
r1= 1 ring, r2= 2 rings, r3= 3 rings, r4= 4 rings, r5= 5 rings, ts= toll saver
(the call is answered after 2 rings when messages have been recorded and after 4
rings when no messages have been recorded, see 10. Remote control).
3. Press the STOP button to end the programming or the /PROG button to pass
to the following setting.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals