28 29
Mira 200 Mira 200
going message 2, followed by 2 short beeps. Now you have 5 seconds to enter the
first digit of your remote control code. If you wait longer then 5 seconds, the con-
nection is broken automatically.
* When the answering machine is turned off, the line is automatically answered after
15 rings and you will hear 2 short beeps. Now you have 5 seconds to enter the
first digit of your remote control code. If you wait longer then 5 seconds, the con-
nection is broken automatically.
2. According to the mode in which the answering machine is set, enter the 3 digit
remote control code after the beep or after the 2 short beeps.
R e m a r k :
It is very important that you wait after entering each digit until you hear a short con-
firmation beep. When the digits are entered too fast after each other, a part of the
code is lost. When the 3 digits are correct, you will hear 2 short confirmation beeps.
When you have entered a wrong code, after the last digit you will hear a long beep.
Now enter the correct remote control code.
3. Press the corresponding numbers of the desired function:
11 : PLAYBACK OF THE NEW MESSAGES
12 : PLAYBACK OF ALL MESSAGES
During the playback of the messages, you have the following possibilities:
0: PAUSE
Press 0 to interrupt the playback and press 0 again to continue the playback
(if you do not press 0 within 30 seconds in order to continue the playback,
the playback stops).
3: ERASING A MESSAGE
Press 3 to erase the message that is being played.
4: PREVIOUS MESSAGE
Press 4 to go to the previous message.
5: REPEATING A MESSAGE
Press 5 to repeat a message.
9.15. BACKUP BATTERY ALMOST EMPTY
The 9V backup battery avoids the memory from being erased in case of a power fail-
ure. The display of the base station shows “LO” when the battery is almost empty and
the 9V battery has to be replaced. The battery compartment is situated on the bottom
of the base station.
9.16. RESET (RELOADING THE STANDARD SETTINGS)
In order to reload the standard settings in the answering machine, proceed as follows:
remove the adaptor plug from the backside of the base station.
Press simultaneously the rewind button, the playback button and the
STOP button and reconnect the plug while you keep the buttons pressed until “rr”
appears on the display of the base station.
Now the standard setting are reloaded in your answering machine and all messages
and outgoing messages are erased.
10. REMOTE CONTROL
You can operate your Mira 200 through the telephone line from another location. Be
sure to use a telephone, set to tone dialling (DTMF).
If you often use the remote control function, it is best that you set your answering
machine to ‘toll saver’ (see 9.5. Setting the number of rings).
Your call is then answered after 2 rings when new messages have been recorded.
When no new messages have been recorded, a call will only be answered after 4
rings. You can then hang up after 3 rings so that you know for free that no new mes-
sages have been recorded.
In order to operate the Mira 200 through the telephone line, proceed as follows:
1. Dial the telephone number to which your answering machine is connected.
* If you call the answering machine when it is set to An-mode, you will hear
outgoing message 1. After the beep you can enter the 3 digit remote control code.
If you call the answering machine when it is set to nA-mode, you will hear out-
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals