Topcom Butler 800 User's Guide download pdf (Page 19)

Topcom Butler 800/Twin 19

Topcom Butler 800/Twin

ENGLISH

6. MANAGING MULTIPLE HANDSETS

6.1 SETTING UP AN ADDITIONAL HANDSET

You can register new handsets on the base if these handsets support the DECT GAP

protocol.

The base can support a maximum of 2 handsets. If you already have 2 handsets, and you

wish to add another one or change one handset, you must first delete a handset, then

associate the new handset.

To register any handset, the base must be put into a special registration mode:

1. Press and hold the paging key of the base for 6 seconds.

2. The base will then emit a beeptone. The base is now ready to register a new handset.

You have 90 seconds after pressing the button to register a new handset.

After putting the base into registration mode, start the procedure on the new handset:

your additional handset is a Butler 800

3. Enter the menu by pressing /OK

4. Select REGISTER using the up and down keys

5. Press OK

6. Select REG BASE using the up and down keys

7. Enter a base number ( from 1 to 4 ). The flashing numbers are already in use.

8. Enter the Base PIN code (0000 by default )

9. Press OK. The handset will start searching for the DECT base

10. If the handset has located the base, it will display the base identification number, validate

the

base registration by pressing OK or stop by pressing .

11. If the handset does not locate the base, it will return to the standby mode after a few

seconds.

Try again by changing the base number and check that you are not in a environment

where there

is interference. Move closer to the base.

if your handset is another model

After starting the registration procedure on the base, refer to the handset manual to find out

how to register the handset. The handset must be GAP compatible.

The icon and the text "NOT REG" flashes on the display when the handset is not

associated with the base.

When a handset is associated with a base, it is attributed a handset number by the base. It

is this number that is displayed on the handset after the name and must be used for internal

calls.

You only need to register a 2nd handset in case your 2nd handset does not

link with the base anymore or when you have bought a new one !!!

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Topcom Butler 800 User's Guide Page 19